Threading The Machine - Consew 226R Operating Instructions Manual

8
THREADING THE MACHINE (Fig. 10)
1. Raise the needle bar to its highest point and lead the thread from the thread
stand the following order:
From the thread stand lead the thread from back to front through the lower
guide hole in pineDon top of the machine arm, then again from right to left
through the upper guide hole in this pin. Pass thread in weaving fashion thro-
ugh the three holes in guide@, and from right to left over and between the
t€!Osiondiscs:ID.Now pull thread downward and from right to left beneath
and around thread controller<1),continue to pull thread upward against the
pressure of the wire sp.ring into the fork@, in the thread controller. Guide
upward through the point of controller discs:§), and thread guide(V, and from
right to left through the eye in take-up lever@, down through thread guide(V,
again and then through@, @J,@, and from left to right through the eye of
the needle@).
2. Mter the above threading, hold the end of thread with your left hand, and
turn the machine pulley with your right hand so that bobbin thread may be
picked up by needle thread. And put their ends of thread back through under
the presser foot for starting operation.
TO REMOVE THE WORK
Raise the needle bar to its highest point, lift the presser foot and draw the
fabric back and to the left. Cut the ends of the threads a few centimeters.
@~
r ..,
[j:.
Fig. 10