Usage Instructions - Singer SDM-1045BLIN Instruction Manual

Drink mixer
Table of Contents

Advertisement

Available languages

Available languages

  • ENGLISH, page 1
STIRRING VESSEL
1. Please ensure that the drive shaft is installed properly at the bottom of the stirring cup.
2. The food volume should not exceed the maximum capacity of the stirring cup.
3. The temperature for stirring the food should not exceed 80 centigrade.
4. Do not put your fi ngers or any thing into the stirring cup when it is connecting to the electricity
supply. Only when the electricity supply is cut off, can you deal with the food attached to the
wall of the stirring cup.
5. Do not move the stirring cup when it is still at work.
EQUIPPED WITH SAFETY LOCK
1. The product is equipped with a safety lock. Only when the head is pushed down to the cup,
the appliance will work.
2. Notice: do not use the stirring cup instead of the switch.

USAGE INSTRUCTIONS

1. Please clean the parts which contact with the food before you use the product for the fi rst
time(see cleaning)
2. Put the food or drink into the stirring cup under the specifi ed capacity.
3. Put the stirring cup on base, and push down the head. (This is a model with compressible
shaft, please always push the head down to the cup for mixing)
4. Please ensure that the electricity supply is connected.
5. Press the switch button and start the dynamo.
6. During the stirring process, do not put raw material into the cup; only after the electricity
supply is cut off and the machine stops, can raw material be added into the cup.
CLEANING
1. Please use water to clean the parts which contact with the food after using it. Install the
stirring vessel properly (see usage Instruction) add detergent and warm water into the
stirring cup.
2. Press the switch about 10 seconds for cleaning the stirring cup rapidly.
3. Please cut off the power before cleaning it.
4. Generally, dish-washer can not be used to clean the product or the spare parts.
5. Soft wet cloth can be used to polish the dynamo, do not immerse dynamo in water. Do not
use abrasive, brusher or alcohol, etc.
6. Remove the stirring cup and rinse it out with clean warm water.
6
ENGLISH

Advertisement

Table of Contents
loading

Table of Contents