Connecting Via I.link (Fat Only) - Sony PMW-150 Operating Instructions Manual

Note
Do not select "Card Power Off" from the SxS
memory card icon displayed on the menu bar.
Using the application software
To copy clips to the local disk of your computer,
the dedicated application software must be
downloaded and installed on your computer. For
details, see "Software Downloads" (page 125).
Although the data regarding recorded materials
are stored over multiple files and folders, you can
easily handle the clips without considering such
data and directory structure by using the
dedicated application software.
Note
If you operate, e.g. copy the clips on the SxS memory
card by using the Explorer (Windows) or Finder
(Macintosh), the subsidiary data contained by the clips
may not be maintained.
Using a nonlinear editing system
For a nonlinear editing system, optional editing
software that corresponds to the recording
formats used with this camcorder is required.
Store the clips to be edited on the HDD of your
computer in advance, using the dedicated
application software.
Connecting via i.LINK
(FAT only)
When an HDV-compatible video format (SP
1440/50i) or a DVCAM-compatible video format
(format of SD Mode) is selected, setting "SDI/
HDMI/i.LINK I/O Select" (page 83) in the
VIDEO SET menu to "HDV" or "DVCAM"
enables signal inputs/outputs via the i.LINK
(HDV/DV) connector.
You can record the same images as those
recorded on an SxS memory card in this
camcorder on an external device connected to the
i.LINK (HDV/DV) connector, or record playback
pictures of the external device on the memory
card in the camcorder.
DVCAM stream audio is only available in 48 kHz
16-bit 2-channel lock audio format.
Notes
• Use the i.LINK (HDV/DV) connector only for one-to-
one i.LINK connection.
• When you change a setting which affects output
signals from the i.LINK (HDV/DV) connector, such as
"System" in the OTHERS menu or "SDI/HDMI/
i.LINK I/O Select" and "Down Converter" in the
VIDEO SET menu, disconnect the i.LINK cable then
change the setting. Changing such a setting with the
i.LINK cable connected may cause improper operation
of the connected i.LINK device.
i.LINK and are trademarks.

Connecting via i.LINK (FAT only)

99