Toro 41581 Operator's Manual page 25

8. Set the master boom switch and boom control switches
to the On position to begin spraying.
9. Allow all of the water in the tank to spray out though
the nozzles.
10. Check the nozzles to ensure that they are all spraying
correctly.
11. Set the master boom switch to the Off position, set the
pump switch to the Off position, and stop the engine.
12. Repeat steps 3 through 11 at least 2 more times to
ensure that the spray system is fully cleaned.
Important You must always complete this procedure at
least 3 times to ensure that the spray system is fully clean,
preventing damage to the system.
13. Clean the strainer; refer to Cleaning the Suction Strainer
on page 41.
Important If you used wettable powder chemicals,
clean the strainer after each tank.
14. Using a garden hose, rinse off the outside of the sprayer
with clean water.
15. Remove the nozzles and clean them by hand. Replace
damaged or worn nozzles.
16. Rotate the booms upward to the transport position and
latch.
25