3. Raise the levers to the neutral position and align
them by sliding them forward or backward and
tighten the bolts.
4. If the ends of the levers hit against each when rotated
into the drive position, move them to the neutral
position and carefully bend them outward.
5. Move them back to the drive position and check for
clearance.
6. Repeat if necessary.
Figure 3
Figure 4
4
Adding Fuel to the Machine
No Parts Required
Procedure
Note: Make sure both fuel tanks are half full when first
starting the machine. This will prevent air getting into
the fuel system and causing starting problems.
Add fuel to the machine before starting it. Refer to your
Operator's Manual. for the correct fuel and procedure.
3