Table of Contents
Advertisement
Step
4
Adding Fuel to the Machine
No Parts Required
Procedure
Note: Make sure both fuel tanks are half full
when first starting the machine. This will prevent
air getting into the fuel system and causing starting
problems.
Add fuel to the machine before starting it. Refer
to your Operator's Manual. for the correct fuel and
procedure.
Step
5
Charging the Battery
No Parts Required
Procedure
Charging the battery produces gasses that
can explode and cause serious injury.
• Keep cigarettes, sparks and flames away
from the battery.
• Make sure the ignition switch is off.
• Ventilate when charging or using the
battery in an enclosed space.
Important: Do not run the machine with
the battery disconnected; electrical damage
may occur to the engine.
Charge the battery. Refer to the Operator's Manual
for instructions.
Figure 6
Step
6
Checking the Machine for
Grease
Parts needed for this step:
Number 2 general purpose lithium base
1 tube
or molybdenum base grease. (Purchase
separately.)
Procedure
1. Tilt the seat forward.
2. Check the deck lift pivots for grease.
3. Check the pump drive belt idler arm for grease.
4
Advertisement
Table of Contents
