Adding Fuel To The Machine - Toro Z Master Series Setup Instructions

5. Raise the roll bar into the upright position and secure
it with the pins and hairpin cotter pins fastened to
the lanyards
Figure 8
Figure 9
6. Torque all lower fasteners, attached to the machine
frame, to 30 ft-lb.
7. Tighten the center roll bar bolts (1/2 x 3-1/4 inch)
so it rotates freely with some resistance.
Note: No more than one thread should be exposed
outside the nut.
5

Adding Fuel to the Machine

No Parts Required
Procedure
Add fuel to the machine before starting it. Refer to your
Operator's Manual. for the correct fuel and procedure.
4
Figure 10