aqua-pure AP9100+ Installation And Operating Instructions page 3

GUIDE TO REPLACE YOUR CARTRIDGE
1. Turn water supply off. If there is no isolation tap, turn off mains water supply.
2. Turn fi lter tap on to check water supply is off and to release any residual water. Leave fi lter tap in ON position.
3. Remove used AP9950 cartridge by turning it to the left, until the IN/OUT marker
4. Hold cartridge fi rmly and pull downwards. (Be aware there will be approximately 15ml / 1 tablespoon of water spill) (ref fi g b).
5. Drain and dispose of the used cartridge.
6. Remove red plastic cover on new AP9950 cartridge and insert into the head cavity. Align IN/OUT marker
NEP head (ref fi g c).
7. Turn cartridge to the right, until the LOCK marker
8. Slowly turn water supply on. Leave tap at ON position and allow water to run for 2-3 minutes to fl ush the new cartridge.
®
NOTE: Aqua-Pure fi lter systems are designed for ease of installation. However, post-installation inspections are highly recommended. Check for leaks immediately
after installation and once again after 24 hours. If leaks are detected, turn off water supply, drain water and inspect the leaks. If problem persists, contact the installer/
plumber for rectifi cation.
TREATMENT AND TESTS TABLE C1
This appliance meets the domestic water treatment appliance Standards AS/NZS 3497 and AS/NZS 4348 for the following water treatment process.
Class Treatment Type
I Microbiological Status Bacteriostatic
II Microbiological Treatment
II (a) Bacteria Removal
II (b) Virus Removal
II (c) Protozoa Removal
III Turbidity & Particulate Reduction
IV Taste & Odour Reduction
V Chemical Treatment
Legend
NOTE: The use of this appliance may increase the bacterial content of the water unless supplementary treatment is provided.
WATER FILTERS
Please print clearly
Title: Miss / Ms / Mrs / Mr or other, please specify
(please circle)
Name
Address:
Contact No:
Store name
on cartridge aligns to the marker on NEP head (ref fi g d).
Will stop bacteria increasing, but will not remove them unless II (a) is ticked
= Pass Test
Warranty Registration Card
This warranty registration section must be completed,
registered online or posted within 14 days of purchase
aligns to the marker on NEP head (ref fi g a).
on cartridge to the marker on
Function
Will remove inactive bacteria
Will remove inactive virus
Will remove inactive Cryptosporidium and Giardia
Will reduce cloudiness
Will reduce taste and odour
Will decrease chlorine compounds
N/A = Not applicable
3 YEAR WARRANTY & CARTRIDGE
REPLACEMENT PROGRAM
www.aquapure.com.au/warranty
or post this warranty registration card back to us
1. We will keep your warranty registered and safe on your behalf
2. We will send you an annual replacement cartridge reminder
notifi cation
AP9100 + Water Filter System
Suburb:
Email:
Date of Purchase / Installation
a.
b.
c.
d.
Pass
n/a
n/a
n/a
Register online at
State: PCode:
/ /