Step 7: Set Apn, Report Server Ip (At) - esky ES610 Start Manual

If commands are set by AT command, please refer to <serial Readme> to install ES610 device
driver and set hyper terminal.
You can contact our technical support to ask for device driver and <serial Readme>.
If everything is ready, then follow me to enjoy the AT command trip.

3.7 Step 7: Set APN, Report Server IP (AT)

Note: AT command is based on the command in <ES610 protocol>.
If you are not in China or America, APN is necessary to change.
The command to re-set APN and server IP is "GPRS". The format of "GPRS" is shown below.
For example:
The APN of China Mobile is CMNET
The reporting server is esky car online platform:
The default password is the 000000
So the AT command content should be:
cmd=gprs,000000,cmnet,0, www.eskyloacte.com:1750,120#<CR>
www.eskyloacte.com
Report server
APN
Password
AT command mark
cmd=" XXX "