Common Functions; Setting The Display Brightness; Muting The Av Receiver; Using The Sleep Timer - Onkyo TX-SR506 Instruction Manual

Common Functions

This section explains functions that can be used with any
input source.
Press
[RECEIVER]
first
DIMMER
STANDBY/ON
STANDBY
ZONE 2
PURE AUDIO
PURE AUDIO MULTI CH DVD
PHONES
ZONE 2 OFF TONE
PHONES

Setting the Display Brightness

You can adjust the brightness of the display.
Press the [RECEIVER] REMOTE
Remote
controller
MODE button, and then press the
remote controller's [DIMMER]
button repeatedly to select: dim,
dimmer, or normal brightness.
You can also use the AV receiver's
[DIMMER] button (not European mod-
els).
AV receiver
DIMMER
46
DISPLAY
MUTING
SLEEP
DISPLAY
TUNING PRESET
ENTER
VCR/DVR CBL/SAT AUX TAPE TUNER CD SETUP RETURN
SETUP MIC VIDEO
MOVIE/TV MUSIC GAME DISPLAY DIGITAL INPUT DIMMER MEMORY TUNING MODE
CLEAR
DIMMER

Muting the AV Receiver

You can temporarily mute the output of the AV receiver.
To unmute the AV receiver, press the remote control-
ler's [MUTING] button again, or adjust the volume. The
output is unmuted and the MUTING indicator goes off.
Muting is cancelled when the AV receiver is set to
Standby.

Using the Sleep Timer

With the sleep timer, you can set the AV receiver so that
it turns off automatically after a specified period.
MASTER VOLUME
AUX INPUT
L AUDIO R
To cancel the sleep timer, press the [SLEEP] button
repeatedly until the SLEEP indicator disappears.
To check the remaining sleep time, press the [SLEEP]
button. Note that if you press the [SLEEP] button while
the sleep time is being displayed, you'll shorten the sleep
time by 10 minutes.
Press the [RECEIVER] REMOTE
MODE button, and then press the
remote controller's [MUTING]
button.
The output is muted and the MUTING
indicator flashes on the display.
Press the [RECEIVER] REMOTE
MODE button, and then press the
remote controller's [SLEEP] but-
ton repeatedly to select the
required sleep time.
You can set the sleep time from 90 to 10
minutes in 10 minute steps.
The SLEEP indicator appears on the
display when the sleep timer has been
set, as shown. The specified sleep time
appears on the display for about 5 sec-
onds, then the previous display reap-
pears.
SLEEP indicator