Starting And Stopping The Engine - Toro 74941CP Operator's Manual

Close the fuel shut-off valve for transport, maintenance,
and storage.
Ensure the fuel shut-off valve is open when starting
the engine.
1
2
G008948
Figure 18
1. On
Starting and Stopping the
Engine
Starting the Engine
1. Raise the ROPS up and lock into place, sit on the
seat and fasten the seat belt.
2. Move the motion controls to neutral locked
position.
3. Set the parking brake; refer to Setting the Parking
Brake.
4. Move the blade control switch (PTO) to the Off
position (Figure 19).
5. Move the throttle lever midway between the Slow
and Fast positions.
2. Off
6. Turn the ignition key to the Start position
(Figure 17). When the engines starts, release the key.
Important: Do not engage starter for more
than 5 seconds at a time. If the engine fails
to start allow a 15 second cool-down period
between attempts. Failure to follow these
instructions can burn out the starter motor.
Note: Additional starting cycles may be required
when starting the engine for the first time after the
fuel system has been without fuel completely.
1. Off
2. Run
19
Figure 19
G008947
Figure 20
3. Start