Servicing The Spark Plug - Toro 74941CP Operator's Manual

1
3
5
Note: Ensure the oil filter gasket touches the engine
and then an extra 3/4 turn is completed.
3. Fill the crankcase with the proper type of new oil;
refer to Changing the Oil.
2
4
6
3/4
Figure 48

Servicing the Spark Plug

Service Interval: Every 100 hours
Make sure the air gap between the center and side
electrodes is correct before installing the spark plug.
Use a spark plug wrench for removing and installing
G008804
the spark plug(s) and a gapping tool/feeler gauge to
check and adjust the air gap. Install a new spark plug(s)
if necessary.
Type: NGK
Air Gap: 0.030 inch (0.75 mm)
Removing the Spark Plug
1. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
2. Disengage the PTO, move the motion control levers
to the neutral locked position and set the parking
brake.
3. Remove the lefthand hydraulic unit shroud in the
order listed with Figure 49. This gives you access
to the front spark plug.
G008748
36
® BPR4ES or equivalent