Table of Contents
Advertisement
Changing the Back Position
The back of the seat can be adjusted to provide a
comfortable ride. Position the back of the seat where it
is most comfortable.
To adjust it, turn the knob, under the right-side arm
rest, in either direction to provide the best comfort
(Figure 32).
Figure 32
1. Back rest knob
2. Seat position adjustment
lever
Using the Drive Wheel Release
Valves
WARNING
Hands may become entangled in the rotating drive
components below the engine deck, which could
result in serious injury.
Stop the engine, remove the key, and allow all
moving parts to stop before accessing the drive
wheel release valves.
3. Right-side arm rest
4. Armrest adjustment knob
WARNING
The engine and hydraulic drive units can become
very hot. Touching a hot engine or hydraulic drive
units can cause severe burns.
Allow the engine and hydraulic drive units to cool
completely before accessing the drive wheel release
valves.
The drive wheel release valves are located in the back of
each hydraulic drive unit, under the seat.
Note: Make sure the release valves are in the fully
horizontal position when operating the machine or
severe damage to the hydraulic system can occur.
1. Disengage the PTO (blade control switch) and turn
the ignition key to off. Move the levers to neutral
locked position and apply parking brake. Remove
the key.
2. Rotate the release valve levers vertically to push the
machine. This allows hydraulic oil to by-pass the
pump enabling the wheels to turn (Figure 33).
3. Disengage parking brake before pushing.
1. Vertical to push the
machine
4. Rotate the release valve levers horizontally to run
the machine (Figure 33).
Using the Side Discharge
The mower has a hinged grass deflector that disperses
clippings to the side and down toward the turf.
25
Figure 33
2. Horizontal to run the
machine
Advertisement
Table of Contents
