Craftsman 247.889720 Operator's Manual page 9

4. Place chute onto chute base and ensure chute control rod is positioned under
handle panel. Install hex bolt previously removed but do not secure with
wing nut at this time. See Figure 4.
5. Squeeze the trigger on the handle panel joystick and rotate the chute by
hand to face forward. The holes in the chute control input will be facing up.
See Figure 5.
NOTE: The chute will not rotate without squeezing the trigger on the joystick.
6. Rotate the joystick to the one o'clock position so the silver indicator arrow on
the input shaft below the control panel points upward. See Figure 6.
NOTE: The joystick will be angled slightly to the right. See Figure 5 & Figure 6.
Figure 4
ASSEMBLY
9
Chute Control
Top View
Input
Joystick
Figure 5
Front View
Joystick
Figure 6