Setting The Clock - Onkyo T-4711 Instruction Manual

Setting the clock

1
Remote control
ADJUST
2
Remote control
ENTER
3
Remote control
TIMER
TIMER
PRESET
4
Remote control
ENTER
16
3
This unit features "ACCUCLOCK"-an automatic clock adjusting fea-
ture using RDS broadcast signals.
Using the ACCUCLOCK function to set the clock
(for remote control only)
NOTE:
Before setting the clock, be sure to preset a station frequency.
Make sure that your FM antenna has been properly connected as
explained in page 7. It is strongly recommended that you install an
outdoor FM antenna since the attached T-shaped FM antenna may
not be able to receive RDS broadcasts well enough to allow
ACCUCLOCK function properly.
The clock will display the time in 24 hours. For example, 5:30 pm
will be displayed as "17:30".
(Carry out the following procedure in STAND-BY.)
1. Press the ADJUST button until "ACCUCLOCK On (Off)" is
displayed.
If "ACCUCLOCK Off" is displayed, press the a/b buttons until
"ACCUCLOCK On" is displayed.
2. Press the ENTER button to display a preset station frequency.
3. Press the A/B buttons to tune in a station.
It is recommended to tune in a station with a clear reception.
4. Press the ENTER button.
The day and time appear on the display and "AUTO" flashes.
After a short while, "AUTO" lights up.
After the clock is initially set, it will be adjusted periodically.
NOTE:
Even if an RDS signal is present, the signal may not be strong
enough to allow the ACCUCLOCK to automatically set the time.
AUTO
If this occurs, set the clock manually. (See page 17.)
You may wish to adjust the clock yourself because the time infor-
mation may differ depending on the RDS station detected. If so,
follow the manual clock adjustment procedure described on page
AUTO
17.
There may be cases in which you can listen to radio broadcasts but
cannot use the ACCUCLOCK function.
If ACCUCLOCK cannot be used:
Repeat step 1. above to display "ACCUCLOCK Off" and turn off
ACCUCLOCK.
1
2, 4