Onkyo T-4711 Instruction Manual page 11

7
PRESET / TUNING
Remote control
ANTENNA
A
or
SIGNAL STRENGTH
8
Remote control
MEMORY
DIMMER MEMORY MODE
ANTENNA
or A
SIGNAL STRENGTH
1
PRESET/
TUNING
2
or
DISPLAY GROUP SCAN
3
PRESET / TUNING
DIMMER
1
Remote control
GROUP
or
DISPLAY GROUP SCAN
DIMMER
a
TIMER ANTENNA RDS TUNED STEREO MONO NORMAL NARROW HI-BLEND AUTO FINE MEMORY
W.DAY
A B TP TA
W.END
ONCE
SLEEP SIGNAL STRENGTH
PRESET
TUNED STEREO NARROW HI-BLEND AUTO
TUNED STEREO NARROW HI-BLEND AUTO
ANTENNA TUNED STEREO
A
SIGNAL STRENGTH
Remote control
GROUP
Remote control
PRESET
or
MEMORY MODE
2
Remote control
SCAN
or
PLAY GROUP SCAN
Remote control
DIMMER
MEMORY MODE
or
CLEAR
b
c
7. When the flashing channel is not the desired channel, turn the
PRESET/TUNING dial and select a different channel.
If a station frequency has already been memorized in the
selected channel, the channel number will flash quickly.
MEMORY
Each group contains ten channels.
The channel can also be entered using the number buttons on the
remote control. If this is done, skip step 8.
8. Press the MEMORY button.
NOTE:
40 channels are available for storing preset stations.
MEMORY
Selecting a preset station
NARROW
1. Press the PRESET/TUNING button until Preset Mode is
selected.
With each press of the button, the mode changes one at a time in
the following sequence:
PRESET
Continue pressing the PRESET/TUNING button until "PRESET"
appears on the display.
Skip this step if the remote control is used.
2. Use the GROUP button to select a group (A ~ D).
3. Use the PRESET/TUNING dial to select the desired channel.
To select a preset station using the remote control:
Press the PRESET a/b buttons.
To cancel a preset station:
1. Select the preset station as explained in the previous section.
2. While holding the MEMORY button, press the MODE button.
"--" will be shown on the MEMORY channel display.
Scanning through the preset channels
(Preset Scan Tuning)
1. Press the GROUP button, then select the group that you wish to
scan.
2. Press the SCAN button.
The stations in the preset channels are played one after another
for a few seconds each. Once you have found a station that you
wish to continue listening to, press the SCAN button again to
stop scanning.
If only one station has been stored in the selected group, the
channels are not scanned.
Using the DIMMER button
The part of the display that is lit up changes with each press of the
DIMMER button in the following sequence: Entire display lights up
Section [a] goes off
goes off Entire display lights up...
If the DIMMER button is pressed in stand-by mode:
In stand-by mode, each press of the DIMMER button changes the
time display to one of the four brightness levels.
TUNING CHARACTER
Section [b] also goes off Entire display
11