Entering Characters - Onkyo T-4711 Instruction Manual

Entering characters

1
ANTENNA TUNED STEREO
A
SIGNAL STRENGTH
2
PRESET/
TUNING
3
PRESET / TUNING
4
IMMER MEMORY MODE
5
DIMMER MEMORY MODE
DIMMER
2
4, 5
NARROW HI-BLEND AUTO MEMORY
TUNED STEREO NARROW
TUNED STEREO NARROW
TUNED STEREO NARROW
ANTENNA
A
SIGNAL STRENGTH
ANTENNA TUNED STEREO NARROW
A
SIGNAL STRENGTH
ANTENNA TUNED STEREO NARROW
A
SIGNAL STRENGTH
ANTENNA TUNED STEREO NARROW
A
SIGNAL STRENGTH
MEMORY MODE
3
The following characters can be used.
A B CD EF G H IJ K LM N O P Q R ST U VW X Y Z
a bc d e fg hi jklm no pq rs tu v wx y z !
" & % ' ( ) * + , - . / = ? : ; < > [ ] | @ \
01 23 45 6 78 9
T-4711
Entering new characters
If the station you are currently listening to on the T-4711 is an RDS sta-
tion, the program service name has priority over other information.
Therefore you will not be able to enter characters for the station name.
1. Select the station you wish to name (see previous sections).
2. Press the PRESET/TUNING button until Character Mode is
selected.
With each press of the button, the mode changes one at a time in
the following sequence:
PRESET
Continue pressing the PRESET/TUNING button until "PRESET"
appears on the display.
After a few seconds, "[_
3. Use the PRESET/TUNING dial to select a character.
4. Press the MEMORY button to store the character.
Repeat the procedures 3 and 4 to store more characters. You can
store up to 8 characters in all.
When you want to leave a space between characters, press the
MEMORY button. The bar moves on to the next position.
5. Press the MEMORY button while the underline is at the
eighth character position to finish entering characters.
NOTE:
If you have not pressed a button for 16 seconds, the operation will
complete automatically.
Use the procedure mentioned above to change characters that have
already been entered.
Changing the characters while they are being entered:
Before pressing the MEMORY button to finish entering the charac-
ters, press the PRESET/TUNING button to change the flashing "_"
within the brackets to "
move " " until it is at the character that you wish to change, then
press the PRESET/TUNING button so that "_" appears. After using
the PRESET/TUNING dial to select the correct character, press the
MEMORY button to finish entering the characters.
Clearing all the characters stored in memory
1. After choosing the station whose characters you wish to clear,
press the PRESET/TUNING button until Character Mode is
selected.
2. When "[_
MEMORY button and press the MODE button.
TUNING CHARACTER
]" appears on the display.
". Turn the PRESET/TUNING dial to
]" appears on the display, hold down the
15