No Parts Needed; Roll Bar, Right Section; Roll Bar, Left Section; Roll Bar, Center Section - Toro Z500 Series Z Master Setup Instructions

Step
12

No parts needed.

Key
Operator's Manual
13
Engine Owner's Manual
Parts Catalog
Safety video
Registration card
Step
1
Raising the Machine Up
Parts needed for this step:
None
Procedure
1. Remove the wheel
nuts from both sides of
the vehicle.
2. Remove the right
angle retaining plate
from the crate and the
wheel hub.
3. Raise the back of the machine up and support it
with jack-stands.
2
Description
m–7793
m–7794
Qty.
– Checking the machine before delivery
2
1
1
Delivering the Machine to the Customer
1
1
1
Step
2
Installing the Roll Over
Protection System (ROPS)
Parts needed for this step:
Qty.
1

Roll bar, right section

1

Roll bar, left section

1

Roll bar, center section

8

Bolt, 3/8 x 1 inch

8

Curved washer

8

Flange nut, 3/8 inch

2

Bolt, 1/2 x 3-1/4 inches

2

Flange nut, 1/2 inch

2

Lanyard

Procedure
Note: If you are installing a DFS bagger while setting
up a machine, install the DFS bagger frame before
the ROPS.
1. Loosely install the right and left roll bar sections
to the frame, with 8 bolts (3/8 x 1 inch), 8 curved
washers and 8 flange nuts (3/8 inch).
Note: The spring disk cone must be installed toward
the bolt head.
Use
Part