Anit-Tip Device Installation - Viking 5 SERIES Installation Manual

Anti-tip Device Installation (Wall Mount)
WARNING
Tipping hazard.
To reduce the risk of property
damage or personal injury;
install anti-tipping device
provided in accordance with
the installation instructions
in this document. Device
must be engaged properly to
prevent product from tipping
over.
Y Y
2
n t n t n t
m e m e m e
m ) m ) m )
3 c 3 c 3 c
u r e u r e u r e
( 1 . ( 1 . ( 1 .
a s a s a s
/ 2 " / 2 " / 2 "
M e M e M e
+ 1 + 1 + 1
Locate anti-tip bracket on rear wall with the top left
corner at measurement (A) plus 1/2" (1.3 cm) from the
floor and "X" dimension (see chart) from where the
right side of range (facing range) is to be located and
"Y" dimension (see chart) from where the left side of
the range (facing range) is to be located.
3
Mark and drill holes where bracket will be located.
of the anti-tip opening located on the back of range.
X X
) ) )
( A ( A ( A
22
1
M e M e M e
Measure from floor to bottom
This will be measurement (A).
Range "X"
Width Dimension Dimension
30" 3-5/8" (9.2 cm)
36" 8" (20.3 cm)
48" 5" (12.7 cm)
60" 5" (12.7 cm) 24-7/8" (63.2 cm)
Anti-tip location for each range width.
4
Attach bracket with
mounting hardware provided.
a s a s a s
u r u r u r
e m e m e m
e n e n e n
t ( t ( t (
A ) A ) A )
"Y"
N/A
N/A
N/A