Storage; Cleaning And Storage - Toro 30071 Operator's Manual

Storage

Cleaning and Storage

1. Disengage the power take off (PTO), set the parking
brake, and turn the ignition key to off and remove the
key.
2. Remove grass clippings, dirt, and grime from the
external parts of the entire machine, especially the
engine.
3. Clean dirt and chaff from the outside of the engine's
cylinder head fins and blower housing.
Important: You can wash the machine with mild
detergent and water. Do not pressure wash the
machine. Avoid excessive use of water, especially
near the drive system and engine. Pressure
washing can force dirt and water into critical parts,
such as spindle bearings and electrical switches.
4. Check the brake; refer to
29).
5. Service the air cleaner; refer to
Cleaner (page 21).
6. Grease the machine; refer to
(page 20).
7. Change the engine oil; refer to
Oil (page 22).
8. Check the tire pressure; refer to
Pressure (page 26).
9. For long-term storage:
A. Add stabilizer/conditioner additive to fuel in the
tank.
B. Run engine to distribute conditioned fuel through
the fuel system (5 minutes).
C. Stop engine, allow to cool and drain the fuel tank;
refer to Fuel System Maintenance (page
operate engine until it stops.
D. Start engine and run until it stops. Repeat, on
Choke until the engine does not start.
E. Dispose of fuel properly. Recycle as per local
codes.
Note: Do not store stabilizer/conditioned
gasoline over 90 days.
10. Remove the spark plug(s) and check its condition; refer
to Servicing the Spark Plugs (page
plug(s) removed from the engine, pour 2 tablespoons
of engine oil into the spark plug hole. Now use the
starter to crank the engine and distribute the oil inside
the cylinder. Install the spark plug(s). Do not install the
wire on the spark plug(s).
11. Check and tighten all bolts, nuts, and screws. Repair or
replace any part that is damaged or defective.
Checking the Brakes (page
Servicing the Air
Lubricating the Machine
Changing the Engine
Checking the Tire
24), or
23). With the spark
12. Paint all scratched or bare metal surfaces. Paint is
available from your Authorized Service Dealer.
13. Store the machine in a clean, dry garage or storage area.
Remove the key from the ignition switch and keep it
in a memorable place. Cover the machine to protect
it and keep it clean.
43