Replacing The Fuel Filter; Electrical System Maintenance; Servicing The Fuses - Toro 30071 Operator's Manual

8. Slide the hose clamp close to the valve to secure the
fuel line.
9. Wipe up any spilled fuel.

Replacing the Fuel Filter

Service Interval: Every 200 hours or yearly, whichever
occurs first.
Never install a dirty filter if it is removed from the fuel line.
Note: Note how the fuel filter is installed in order to install
the new filter correctly.
Note: Wipe up any spilled fuel.
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Close fuel shut-off valve at the fuel tank
4. Squeeze the ends of the hose clamps together and slide
them away from the filter
Figure 28
1. Hose clamp
2. Fuel line
5. Remove the filter from the fuel lines.
6. Install a new filter and move the hose clamps close to
the filter.
7. Open fuel shut-off valve at fuel tank
8. Check for fuel leaks and repair if needed.
9. Wipe up any spilled fuel.
(Figure 28).
(Figure 28).
3. Filter
(Figure 28).
Electrical System
Maintenance

Servicing the Fuses

The electrical system is protected by fuses. It requires no
maintenance. If a fuse blows, check the component or circuit
for a malfunction or short.
1. Remove the cover under the control panel.
2. Pull out on the fuse to remove or replace it
3. Install the cover under the control panel.
1. Fuse, 10 amp, blade type
25
(Figure
Figure 29
2. Fuse, 20 amp, blade type
29).