Toro 30071 Operator's Manual page 39

7. Align the carrier frame and engine deck to match 33
mm (1-5/16 inch), plus or minus 6 mm (1/4 inch) at
location A (Figure
8. Tighten the carrier frame mounting bolts on both sides
of the machine.
1. Carrier frame
2. Top of engine deck
3. Carrier frame mounting
bolts
Checking the Engine Deck Height
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Adjust the tire pressure in the rear tires to specifications;
refer to Drive System Maintenance (page
4. Measure engine deck height at location A
5. Measure engine deck height at location B
6. If the height at location A and B are not the same,
change tire pressure slightly to make them the same.
54).
Figure 54
4. Location A, 33 mm (1-5/16
inch) plus or minus 6 mm
(1/4 inch)
5. Straight edge
6. Carrier frame cross
channel
26).
(Figure
(Figure
1. Back view of machine
2. Top of engine deck
Checking the Carrier Frame
Front-to-Rear Pitch
The carrier frame must have a pitch between 3 mm (1/8 inch)
to 9 mm (3/8 inch) over the length of 61 cm (24 inches) on
the carrier frame
1. Measure out 61 cm (24 inches) on the carrier frame
(Figure 56).
1. Carrier frame
2. 3 to 10 mm (1/8 inch to 3/8
55).
inch) pitch over 61 cm (24
inch) length
55).
3. 61 cm (24 inches)
2. Measure carrier frame height at location A
3. Measure carrier frame height at location B
4. The height at location A must be an 3 mm to 10 mm
(1/8 to 3/8 inch) lower than location B
5. If the carrier frame is not correct, move the caster
spacers to make it an 3 mm to 10 mm (1/8 to 3/8
inch) pitch
Note: Move spacers from top or bottom to make the
correct pitch.
39
Figure 55
3. Tires
4. Same height at locations
A and B
(Figure 56).
Figure 56
4. Height at locations A and
B
5. Caster wheel
6. Caster spacers
(Figure 56).
(Figure 56).
(Figure 56).
(Figure 56).