Toro 30071 Operator's Manual page 33

1. Cam
2. Nut and bolt
3. Wing nut
3. Adjust the cam until it aligns with the left
motion-control lever and tighten the nut and bolt for
the cam.
After the cam is adjusted, the lever switch needs to be
checked.
1. Check the gap between the control lever and switch as
shown in Figure 43.
Note: The gap needs to be an 3 mm (1/8 inch).
Figure 42
4. Turnbuckle
5. Switch screws
Shown from the front
1. Right motion-control lever
pivot shown under controls
2. Right motion-control lever
2. If needed, loosen the screws holding the switch and
adjust the switch
3. Tighten the screws and install the cover under the
control panel.
Adjusting the Neutral Position for the
Motion-Control Levers
Important: Ensure the tracking of the mower is correct
after adjusting the motion-control levers. After adjusting
the tracking, the motion-control levers may not align the
exactly front to back
If the motion-control levers do not align front to back,
or the right control-lever does not move easily into the
Neutral-Lock position, adjust it. Adjust each lever and control
rod separately.
Note: Adjust the horizontal alignment before the front to
back alignment.
1. After the horizontal alignment is finished, check the
front to back alignment
33
Figure 43
3. 3 mm (1/8 inch) gap
needed between switch
and control lever
4. Switch
(Figure 43).
(Figure 44).
(Figure 44).