Storage; Cleaning And Storage - Toro 30632 Operator's Manual

Storage

Cleaning and Storage

1. Disengage the power take-off (PTO), set the parking
brake, and turn the ignition key to the off position.
Remove the key.
2. Remove grass clippings, dirt, and grime from the
external parts of the entire machine, especially the
engine. Clean dirt and chaff from the outside of the
engine cylinder-head fins and the blower housing.
Important: You can wash the machine with mild
detergent and water. Do not pressure wash the
machine. Avoid excessive use of water, especially
near the shift-lever plate and the engine.
3. Check the brake; refer to Brake Maintenance (page 30).
4. Service the air cleaner; refer to Servicing the Air
Cleaner.
5. Grease the machine; refer to Lubrication (page 23).
6. Change the crankcase oil; refer to Servicing the Engine
Oil (page 24).
7. Check the tire pressure; refer to Drive System
Maintenance (page 29).
8. For long-term storage:
A. Add stabilizer/conditioner additive to fuel in the
tank.
B. Run the engine to distribute conditioned fuel
through the fuel system (5 minutes).
C. Stop the engine, allow it to cool, and drain the
fuel tank; refer to Draining the Fuel Tank (page
27), or run the engine until it stops.
D. Start the engine and run it until it stops. Repeat
the process, with the choke on, until the engine
will not start.
E. Dispose of fuel properly. Recycle it as per local
codes.
Note: Do not store stabilizer/conditioned
gasoline over 90 days.
9. Remove the spark plug(s) and check the condition;
refer to Servicing the Spark Plug. With the spark
plug(s) removed from the engine, pour 2 tablespoons
of engine oil into the spark-plug hole. Now use the
starter to crank the engine and distribute the oil inside
the cylinder. Install the spark plug(s). Do not install the
wire on the spark plug(s).
10. Check and tighten all bolts, nuts, and screws. Repair or
replace any part that is damaged or worn.
11. Paint all scratched or bare metal surfaces. Paint is
available from your Authorized Service Dealer.
12. Store the machine in a clean, dry garage or storage area.
Remove the key from the ignition switch and keep it
in a memorable place. Cover the machine to protect
it and keep it clean.
41