Toro 38272 Operator's Manual page 18

1. Carburetur bowl bolt—do
not remove
C. Wait for a few minutes until the fuel has drained,
then install the fuel cap and tighten the small
screw on the carburetor.
5. Dispose of unused fuel properly. Recycle it according
to local codes, or use it in your automobile.
6. Remove the spark plug.
7. Squirt 2 teaspoons of oil into the spark plug hole.
8. Install the spark plug by hand and then torque it to
20–22 ft-lb (27–30 N-m).
9. With the ignition key in the Off position, pull the
recoil starter slowly to distribute the oil on the inside
of the cylinder.
10. Disconnect the ignition key from the lanyard and
store the ignition key in a safe place.
11. Clean the snowthrower.
12. Touch up chipped surfaces with paint available
from an Authorized Service Dealer. Sand affected
areas before painting, and use a rust preventative to
prevent the metal parts from rusting.
13. Tighten any loose fasteners. Repair or replace any
damaged parts.
14. Cover the snowthrower and store it in a clean, dry
place out of the reach of children. Allow the engine
to cool before storing it in any enclosure.
Figure 35
2. Small screw on carburetor
18