Loose Parts; Installing The Handle - Toro 38272 Operator's Manual

Setup

Loose Parts

Use the chart below to verify that all parts have been shipped.
Procedure
1.
2.
3.
4.
5.
6.

1. Installing the Handle

2 Oval-head bolts
2 Curved washers
2 Handle knobs
Procedure
1. Position the ends of the upper handle on the inside
of the lower handle and align the holes.
2. Insert the oval-head bolts into the aligned holes,
with the bolt heads on the outside of the handle
(Figure 3).
Description
Oval-head bolts
Curved washers
Handle knobs
No parts required
Discharge chute assembly
Screws
Washers
Locknuts
Knob
Bottle of engine oil
Ignition key
Lanyard
No parts required
Qty.
2
2 Install the handle.
2
–
Install the recoil starter handle.
1
2
2 Install the discharge chute assembly.
2
1
1 Fill the engine with oil.
1
Assemble and insert the ignition key.
1
–
Adjust the control cable.
1. Oval-head bolt (2)
3. Install the curved washers and the handle knobs
on the oval-head bolts on the inside of the handle
(Figure 3) and tighten the knobs securely.
Important: Ensure that you do not pinch or
kink the control cable.
5
Use
Figure 3
2. Curved washers and
handle knobs