Setup; Installing The Handle; Installing The Recoil-Starter Handle - Toro 38472 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
1

Installing the Handle

Parts needed for this procedure:
2 Oval-head bolts
2 Curved washers
2 Handle knobs
Procedure
1. Position the ends of the upper handle on the inside of
the lower handle and align the holes.
2. Insert the oval-head bolts into the aligned holes, with
the bolt heads on the outside of the handle
Description
Oval-head bolts
Curved washers
Handle knobs
No parts required
Discharge chute
Screws
Washers
Locknuts
Knob
Bottle of engine oil
No parts required
(Figure
Qty.
2
2
2
–
1
2
2
2
1
1
–
1. Oval-head bolt (2)
3. Install the curved washers and the handle knobs on the
oval-head bolts on the inside of the handle
3).
and tighten the knobs securely.
Important: Ensure that the cable is routed to the
outside of the handle.
4
Use
Install the handle.
Install the recoil starter handle.
Install the discharge chute.
Fill the engine with oil.
Adjust the control cable.
Figure 3
2. Curved washers and
handle knobs
(Figure 3)