Positioning The Flow Baffle - Toro GrandStand 74567TE Operator's Manual

Figure 27
1. Cam lock
2. Lever

Positioning the Flow Baffle

The following figures are only recommendations for
use. Adjustments will vary by grass type, moisture
content, and height of grass.
Note: If the engine power draws down and the mower
ground speed is the same, open up the baffle.
Position A
This is the full rear position (see Figure 28). The
suggested use for this position is a follows.
• Use for short, light grass mowing conditions.
• Use in dry conditions.
• For smaller grass clippings.
• Propels grass clippings farther away from the
mower.
3. Rotate cam to increase or
decrease locking pressure
4. Slot
Position B
Use this position when bagging (Figure 29).
Position C
This is the full open position. The suggested use for
this position is as follows (Figure 30).
• Use in tall, dense grass mowing conditions.
• Use in wet conditions.
• Lowers the engine power consumption.
• Allows increased ground speed in heavy conditions.
• This position is similar to the benefits of the Toro
SFS mower.
24
Figure 28
Figure 29