Installing The Chute Crank; Installing The Discharge Chute - Toro 38517 Operator's Manual

Figure 6
6. Tighten the knobs until they are snug.
7. Adjust the control cable. Refer to Adjusting the Control
Cable.
2. Installing the Discharge
Chute
Install the discharge chute as shown (Figure 7).
Figure 7

3. Installing the Chute Crank

1. Insert the end of the chute crank through the hole in
the shroud and align the mounting bracket with the
holes in the lower handle (Figure 8).
Figure 8
1. Chute crank
2. Hole in the shroud
2. Slowly rotate the crank until the end of the chute crank
fits into the hidden gear opening and the discharge
chute turns the crank.
Note: Ensure that the plastic bushing is fully inserted
into the hole in the mounting bracket (Figure 8).
3. Secure the mounting bracket to the handle with 2 bolts
and 2 locknuts.
7
3. Mounting bracket
4. Plastic bushing