Table of Contents
Advertisement
Note: This feature may also be used in conjunction with
cruise control.
Transport Speed
Supervisor (Protected Menu)
Allows the supervisor to set the machine's maximum
transport speed, in increments of 50%, 75% or 100%, at
which the operator can transport (high range).
Refer to Using the InfoCenter LCD Display, in the Operation
section of this manual, for the procedure to set the transport
speed.
Operator
Allows the operator to adjust the machine's maximum
transport speed (high range), within the supervisors
pre-adjusted settings. When in the InfoCenter splash or
main screen, press the middle button (
the speed.
Note: When switching between low and high ranges, the
settings will transfer based on the previous setting. The
settings are reset when the machine is turned off.
Note: This feature may also be used in conjunction with
cruise control.
Checking the Interlock
Switches
CAUTION
If safety interlock switches are disconnected or
damaged the machine could operate unexpectedly
causing personal injury.
• Do not tamper with the interlock switches.
• Check the operation of the interlock switches
daily and replace any damaged switches before
operating the machine.
The machine has interlock switches in the electrical system.
These switches are designed to stop traction when the
operator gets off of the seat when the traction pedal is
depressed. Although the engine will continue to run, it is
strongly recommended that the engine be stopped before
rising from the seat.
To check the operation of the interlock switches, perform
the following procedure:
1. Drive the machine slowly to a large, relatively open
area. Lower the cutting unit, stop the engine, and apply
the parking brake.
2. Sit on the seat and depress the traction pedal. Try to
start the engine. The engine should not crank. If the
3. Sit on the seat and start the engine. Rise from the seat
4. Sit on the seat, engage the parking brake and start the
Using the Rollover Protection
System (ROPS)
icon) to adjust
To avoid injury or death from rollover: keep the
roll bar in the raised locked position and use the
seat belt.
Ensure that the seat is secured with the seat latch.
There is no rollover protection when the roll bar is
in the down position.
• Lower the roll bar only when absolutely
necessary.
• Do not wear the seat belt when the roll bar is
in the down position.
• Drive slowly and carefully.
• Raise the roll bar as soon as clearance permits.
• Check carefully for overhead clearances (i.e.
branches, doorways, electrical wires) before
driving under any objects and do not contact
them.
Important: Lower the roll bar only when absolutely
necessary.
1. To lower the roll bar, remove the hairpin cotters and
33
engine cranks, there is a malfunction in the interlock
system that should be corrected before beginning
operation.
and move the PTO lever to On. The PTO should not
engage. If the PTO engages, there is a malfunction in
the interlock system that should be corrected before
beginning operation.
engine. Move the traction pedal out of the neutral
position. The InfoCenter will display "traction not
allowed" and the machine should not move. If the
engine does move, there is a malfunction in the
interlock system that should be corrected before
beginning operation.
WARNING
WARNING
the two pins (Figure 32).
Advertisement
Table of Contents
