Pto Switch; Seat Adjustments; Cruise Control Switch - Toro 30607 Operator's Manual

automatically move to High or Low idle, depending on which
of the switch is depressed.

PTO Switch

The PTO switch (Figure 4) has two positions: Out (start)
and In (stop). Pull the PTO button out to engage the cutting
unit blades. Push in the button to disengage the cutting unit
blades.
Hi-Lo Speed Control
The switch (Figure 4) allows the speed range to increase for
transport of the machine. Cutting decks will not operate
in high range. To switch between the High and Lo range,
the decks must be raised, PTO disengaged, cruise control
disengaged, traction pedal in neutral position and the machine
must be moving at a slow speed.
Lift Switches
The lift switches (Figure 4) raise and lower the cutting
units. Press the switches forward to lower the cutting units
and backward to raise the cutting units. When starting the
machine, with the cutting units in the down position, press the
lift switch down to allow the cutting units to float and mow.
Note: The decks will not lower while in the HI speed range
and they will not raise or lower if the operator is out of the
seat when the engine is running. Also, the decks will lower
with the key in the On position and the operator in the seat.

Cruise Control Switch

The cruise control switch (Figure 4) locks in the pedal
position to maintain the desired ground speed. Pressing the
rear of the switch turns off the cruise control, the middle
position of the switch enables the cruise control function and
the front of the switch sets the desired ground speed.
Note: Pressing either brake pedal or moving the traction
pedal into the reverse position, for one second, will also
disengage the pedal position.
Power Point
The power point (Figure 5) is used to power optional
electrical accessories.
1. Power point

Seat Adjustments

Fore and Aft Adjusting Lever
Pull out on the lever to slide the seat fore or aft (Figure 6).
Seat Arm Rest Adjusting Knob
Rotate the knob to adjust the seat arm rest angle (Figure 6).
Seat Back Adjusting Lever
Move the lever to adjust the seat back angle (Figure 6).
Weight gauge
Indicates when the seat is adjusted to the weight of the
operator (Figure 6). Height adjustment is made by positioning
the suspension within the range of the green region.
17
Figure 5