Table of Contents
Advertisement
Set-Up
Connect Wire Harness
1.
Secure clutch and engine in–line wire connectors
(Fig. 6).
Figure 6
1. Clutch wire connector
2.
Remove top jam nut from right rear engine
mounting bolt located behind oil dipstick.
3.
Mount remaining wire to engine bolt and secure
with jam nut.
12
2153
2. Engine wire connector
Install Control Rods
1.
Thread a rod fitting onto each control rod
approximately 2 in. (51 mm) (Fig. 7) or until
upper control bar (Fig. 8). is approximately
perpendicular to the ground.
2.
Mount rod fitting ends to mounting holes in idler
brackets (from outside) with clevis pins, washers
and hairpin cotters (Fig. 7).
Figure 7
1. Control rod and fitting
2. 2 in. (51 mm)
3. Idler bracket
2154
4. Clevis pin, washer and
hairpin cotter
Advertisement
Table of Contents
