Table of Contents
Advertisement
Fuel Filter
Service Interval/Specification
Replace the fuel filter after every 100 operating hours
or yearly, whichever occurs first.
Replacing the Fuel Filter
Never install a dirty filter if it is removed from the
fuel line.
1.
Disengage the power take off (PTO), set the
parking brake, and turn the ignition key to
"OFF" to stop the engine. Remove the key.
2.
Close fuel shut–off valve at fuel tank (Fig. 26).
3.
Squeeze the ends of the hose clamps together
and slide them away from the filter (Fig. 27).
4.
Remove the filter from the fuel lines.
5.
Install a new filter and move the hose clamps
close to the filter.
6.
Open fuel shut-off valve at fuel tank (Fig. 26).
2151
Figure 27
1. Hose clamp
2. Fuel line
2
1
3
3. Filter
Replacing the Drive Belt
1.
Remove belt guard, not shown for clarity.
2.
Remove top capscrew securing idler support and
idler bracket to rear frame (Fig. 28).
3.
Loosen bottom two mounting screws enough to
allow belt to pass between drive pulley and idler
support (Fig. 28).
4.
Raise wheel off ground enough to allow belt
removal.
Note:
Check pulleys for wear, replace if
necessary.
3
4
Figure 28
1. Top capscrew
2. Idler bracket
Cleaning the Cooling System
Service Interval/Specification
Before each use, check and clean engine cooling
system. Remove any build–up of grass, dirt or other
debris from the cylinder and cylinder head cooling
fins, air intake screen on flywheel end, and
carburetor–governor levers and linkage. This will
help insure adequate cooling and correct engine speed
and will reduce the possibility of overheating and
mechanical damage to the engine.
Maintenance
1
2
1722
3. Idler support
4. Bottom capscrew
27
Advertisement
Table of Contents
