Checking The Tire Pressure; Lubricating The Machine; Filling The Fuel Tank; Checking The Safety System - Toro DH 200 Setup Instructions

Battery electrolyte contains sulfuric acid that
is poisonous (if consumed) and can severely
burn you.
• Do not drink electrolyte.
• Avoid contact with skin, eyes or clothing.
• Wear safety glasses to shield your eyes and
rubber gloves to protect your hands.
• Fill the battery where clean water is available
for flushing the skin.
• Follow all instructions and comply with all
safety messages on the electrolyte container.
3. Slowly pour electrolyte into each cell until the level is
up to the lower part of the tube.
4. Leave the filler caps off and connect a 3- to 4-amp
battery charger to the battery posts.
5. Charge the battery at a rate of 2 amperes or less for
4 hours (12 volts). Do not overcharge the battery.
Install the filler caps after the battery is fully charged.
Charging the battery produces gasses that can
explode.
Never smoke near the battery and keep sparks
and flames away from the battery.
6. Install the battery in the chassis; refer to the Operator's
Manual.
7

Filling the Fuel Tank

No Parts Required
Procedure
Add fuel to the fuel tank; refer to the Operator's Manual.
8

Checking the Tire Pressure

No Parts Required
Procedure
Check front and rear tires for proper inflation; refer to
the Operator's Manual for the recommended inflation
pressure.
9

Lubricating the machine

No Parts Required
Procedure
Ensure that all of the necessary points on the machine
are lubricated; refer to the Operator's Manual.
10
Inserting the Keys into the
Switches
Parts needed for this procedure:
2 Keys
Procedure
The Key Choice switch is located on the right side of
seat bracket below the seat.
11

Checking the Safety System

No Parts Required
Procedure
Refer to the Operator's Manual.
5