Loose Parts - Toro 38535 Operator's Manual

Setup

Loose Parts

Use the chart below to verify that all parts have been shipped.
Step
1.
2.
3.
1. Installing the Wheels
1. Turn the snowthrower onto its left side and place a
block under the left axle end (Figure 3).
Figure 3
1. Short spacer
2. Slide the short spacer and a wheel onto the right axle
end (Figure 3).
Note: The side of the wheel with 6 spokes must face
downward.
3. Put a pushnut onto the end of the axle and use a
hammer to seat it firmly in place (Figure 4).
Description
Wheels
Long spacer
Short spacer
Pushnuts
No parts required
Discharge chute
Chute handle
Phillips head screws
Washers
Locknuts
Qty.
2
1
Install the wheels.
1
2
–
Install the handle.
1
1
3 Install the discharge chute.
3
3
Figure 4
4. Turn the snowthrower onto its right side and place a
block under the right axle end.
5. Repeat steps 2 through 4 (see note below).
Note: Slide the long spacer and a wheel onto the left
axle end.
2. Installing the Handle
1. Cut the plastic tie that secures the control cable to the
handle.
Note: Hold the cable taut to ensure that it stays
connected at the bottom.
2. Position the upper handle as shown in Figure 5.
5
Use