Utilitech SE1048-BP2-02LF0-U Operating Instructions Manual page 7

OPERATING INSTRUCTIONS
motion sensor during daylight hours regardless of motion detection.
1. The motion sensor must be tested before setting the
time and sensitivity levels. The TEST option is located
on the TIMER control knob on the underside of the
and turn the rotary knob to the "TEST" area. During
test mode, the lights will come on for 40 seconds,
regardless of motion detection or the time of day. The
light will shut off automatically after 40 seconds. Leave
the rotary knob in the "TEST" area and test the
sensitivity by crossing in the path of the sensor. The
light will come on only if it senses movement. Once
movement stops, it will turn off in 5 seconds. The test
is now complete.
2. The control knob located on the opposite side is
marked SENSITIVITY, which determines the degree of
motion detection. Rotating this knob clockwise raises
the sensitivity of the motion sensor for up to 60 ft. of
distance. Rotating the knob counterclockwise lowers
the sensitivity down to as close as 5 ft. It may be
necessary to adjust the "SENSITIVITY" knob
several times until the desired setting is achieved.
NOTE: The higher sensitivity level increases the
likelihood of a false activation being triggered. For
operate in any setting (with power) for at
least 48 hours.
3. The 180 degree coverage of the motion sensor is
measured side to side. Therefore, the sensor will better
(side-to-side), rather than motion coming straight at
the sensor (in-and-out). Adjust the motion sensor head
so that it detects motion moving across the coverage
area. The position of the sensor head should not
exceed 45 degrees from horizontal. Do not aim the
motion sensor at a body of water, bushes or plants that
etc., as this will trigger the motion sensor. NOTE: If the
sensor arm becomes loose, it will not hold the sensor
head at the proper angle. Readjust the sensor head
and tighten the joint screw on the sensor arm.
operation and sensitivity, rotate the rotary knob on the
TIMER control to the "TIMER" area. The "TIMER"
sensor mode. Rotating the knob clockwise increases
the duration of light up to 5 minutes once motion is
detected. Rotating the knob counterclockwise
decreases the duration of light down to 10 seconds
once motion is detected. It may be necessary to
adjust the "TIMER" knob several times until the desired
length of time is determined.
5. To control the security light from inside the home, activate manual "ON" mode by toggling the wall light
switch OFF and ON within 2 seconds. The security light will turn on and stay on for approximately 8 hours,
or until the Dusk-to-Dawn sensor detects light in the morning. Once the Dusk-to-Dawn sensor detects light,
the manual "ON" mode will automatically go back to its original settings of the AUTO motion sensor mode.
nsor that automatically disables the
1
2
3
4
7
45°