Utilitech SE1048-BP2-02LF0-U Operating Instructions Manual page 5

INSTALLATION INSTRUCTIONS FOR ROUND SURFACE MOUNT ELECTRICAL BOXES
7. Restore power to the electrical box at the circuit breaker or
fuse panel. Make sure the wall switch that controls the electrical
box for the security light is returned to the "ON" position
and check that the light is functioning properly. If the light is
screw opening to prevent water seepage into the housing.
Hardware Used
FF
Silicone Cap
INSTALLATION INSTRUCTIONS FOR RECESSED ELECTRICAL BOXES
present, keep track of which wires were connected together.
1. Pull the supply wires out of the electrical box. Using
secure the mounting strap (CC) to the electrical box,
making sure that the side marked "FRONT" is facing out.
Hardware Used
AA
Machine Screws
BB
CC
Mounting Strap
2.
properly grounded. If unfamiliar with the methods of properly
the electrical box is made of plastic and/or has a green or
wire and the electrical box ground wire should be connected
together using the wire nut (DD). If the electrical box is made
of metal and already grounded, secure the bare end of the
using the green grounding screw. Push-in connectors (HH)
connection. Insert the black lead from the electrical box into
the black wire push-in connector (HH). Repeat with the white
leads. Push the excess wires back into the electrical box.
Hardware Used
DD
Wire Nut
HH
Push-in Connector
3. If the LED head is loose and will not hold its position,
tighten the screws that surround the ball joint. NOTE: This
box.
x 1
x 2
GND x 1
FRONT
x 1
x 2
5
1 7
1
2
HH
3
Lowes.com
FF
CC
AA
DD