Package Contents - Utilitech SE1048-BP2-02LF0-U Operating Instructions Manual

PACKAGE CONTENTS

PARTS DESCRIPTION
A LED Head
B Sensor Arm
HARDWARE CONTENTS
Note: Hardware shown actual size.
AA
BB
Machine Machine
Screw
Screw
Qty. 2 Qty. 2
SAFETY INFORMATION
Please read and understand this entire manual before attempting to assemble, operate or install the
product. SAVE THESE INSTRUCTIONS IN A LOCATION CLOSE TO YOUR LIGHT FIXTURE SO
YOU CAN REFER TO THEM AT A LATER TIME.
WARNING
the new one.
• LEDs can be damaged by electrostatic discharge (ESD) shock. Before installation, discharge yourself
by touching a grounded bare metal surface to remove this hazard. To avoid damage, do not remove
the clear lens over the LED module.
CAUTION
• DO NOT USE THIS FIXTURE WITH A DIMMING CIRCUIT. If dimmer controls are present, remove
them and replace them with regular electrical switches. If a three-way dimmer is present, replace it with
electrician do the installation.
• This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
A
B
QUANTITY
2
1
CC DD
Wire Nut
Qty. 1
Mounting Strap
(Not shown
to size)
Qty. 1
D
C
PARTS DESCRIPTION
C Sensor Head
D
EE FF
Silcone
Cap
Long
Qty. 1
Machine
Screw
Qty. 1
2
QUANTITY
Wall Plate
GG
Connector
Foam Gasket
(Not shown
(Not shown
to size)
(Pre-installed
Qty. 1
1
1
HH
Push-in
to size)
Qty. 2