Utilitech SE1048-BP2-02LF0-U Operating Instructions Manual page 6

INSTALLATION INSTRUCTIONS FOR RECESSED ELECTRICAL BOXES
4. Position the wall plate over the mounting strap so
the center hole of the wall plate aligns with the center
hole in the mounting strap. While holding the wall
plate, place the long machine screw (EE) through
the center hole of the wall plate and mounting strap.
Tighten the screw properly to secure the wall plate
onto the mounting surface.
Hardware Used
Long
EE
Machine Screw
head with the adjustment controls and drain holes
facing downward to prevent water damage. The
position of the sensor head should not exceed 45
degrees from horizontal.
6. Restore power to the electrical box at the circuit
breaker or fuse panel. Make sure the wall switch that
controls the electrical box for your security light is
returned to the "ON" position and check that your light
is functioning properly.
If the light is functioning properly, use silicone adhesive
caulking (not included) to caulk the gap between the
wall plate and the mounting surface to prevent water
seepage into the electrical enclosure. Swivel the
adjustable LED heads in the direction where light is
needed.
7. Fit the silicone cap (FF) into the mounting screw
opening to prevent water seepage into the housing.
Hardware Used
FF
Silicone Cap
4
x 1
5
45°
45°
6
1 7
x 1
6
EE
45°
45°
FF
Lowes.com