Connecting Components; Connecting The Power Cord - Onkyo A-933 Instruction Manual

*En_A933_02.fm Page 16 Tuesday, January 25, 2005 1:46 PM
Connecting the A-933 —Continued
Connecting Components
With (Remote Interactive), you can control your
-compatible Onkyo CD player, Tuner, and so on
with the A-933's remote controller.
• To use , you must make an analog audio con-
nection between the A-933 and each audio compo-
nent.
Tuner (T-433) etc.
ACCUCLOCK
STANDBY/ON
DISPLAY
STANDBY
A-933 (Preamp)
STANDBY/ON
ON(G)
STANDBY(R)
SUPER BASS
POWER
PHONES A B
ON OFF SPEAKERS
CD Player (C-733) etc.
STANDBY/ON
DISPLAY
STANDBY
Notes:
• Push each plug in all the way to make a good connec-
tion.
• Use only dedicated
(No cables are supplied with the A-933.)
• The A-933 has four
so you can use any of them.
• jacks should be connected to only Onkyo compo-
nents. Connecting them to another manufacturer's
component may cause it to malfunction.
• Some components may not support all
See the manuals supplied with your other Onkyo
components for more information.
16
TUNING PRESET
CLEAR
MEMORY FM MODE BAND CHARACTER
KEY MODE TUNING / PRESET
M D
LINE TAPE /CDR
C D
TUNER
PHONO
BASS TREBLE
TONE(R) MAIN IN
MAX DIRECT(G)
cables for connections.
jacks. They're all the same,
functions.

Connecting the Power Cord

• Before connecting the power cord, connect all your
speakers and audio components.
• Turning on the A-933 may cause a momentary power
surge, which might interfere with other electrical
equipment on the same circuit. If this is a problem,
plug the A-933 into a different branch circuit.
To wall outlet