Connecting The Cables - Onkyo A-905TX Instruction Manual

Connecting to components other than the Separate Col-
lection Series
Connecting the
If your other components are made by ONKYO and those components are equipped with
tors, you can control the
Before connecting
• The unit must be connected in the
• Each component has two
• The components may be connected in any order.
• The hookups on the previous page are necessary independently of the
The illustration below is an example of a
Connections
Tuner
Amplifier
– this unit
MD recorder
Stereo cassette
tape deck
CD player
AC outlet connection
You can connect the power cord from an-
other audio device to the rear of the A-
905TX.
Since the AC outlet on the unit is a
SWITCHED type outlet, you can use the
POWER switch to turn on/off the power
to both the A-905TX and the connected
audio device.
The shape and capacity of the AC outlet
may differ depending on the area of pur-
chase. Make sure that the capacity of other
components connected to this unit does not
exceed the capacity that is printed on the
14
rear panel.
cables
-connected components with the supplied remote controller.
system hookups for
connectors. There is no difference between these connectors.
hookup.
L
R
TUNER
OUT(REC)
L
R
CDR/PC
230-240 V, 50 Hz models
Capacity is 100 watts.
control operations.
cable (supplied with every ONKYO
component that has
except for the amplifier and receiver)
L
OUT(REC) IN(PLAY) CAUTION:
SPEAKER IMPEDANCE
L
4 OHMS MIN./SPEAKER
SPEAKERS
R
REMOTE
LINE/DVD TAPE
CONTROL R
IN(PLAY) OUT(REC) IN(PLAY)
OUT IN SUBWOOFER
CD MD PROCESSOR PRE OUT
connec-
system hookups.
connectors
AC OUTLET
AC 230-240V
50Hz
SWITCHED
100W MAX.
120 V, 60 Hz models
Capacity is 120 watts.