Radio Operation - Akai ASB70I Operator's Manual

1.) Press the STANDBY/ON button to turn the system 'On'.
The display lighting comes on and the display briefly
shows "HELLO".
2.) Press the FUNCTION button to select the Tuner function.
An MW or FM frequency will apperar on the display.
Press the TUNER/BAND button to switch
between the MW and FM bands if necessary.
3.) Tune to the desired station as follows:
Manual Tuning
Repeatedly press the SKIP/TUNING
frequency of the desired station. Use the Manual Tuning method to tune to stations that
are not strong enough to be recognized by the Automatic Tuning system.
Automatic Tuning
Press and hold the SKIP/TUNING
release the buttons. The Tuner will search up or down the band for the next strong signal
and stop on that station. Reqeat this procedure until the tuner stops on your desired station.
4.) If you tuned to an FM Stereo station the ST indicator will
appear in the display. If the FM Stereo reception is
noisy or weak, press the ST/ESP/ID3/FIND button
on the remote control to select the FM Mono mode.
5.) Adjust the VOLUME, DBBS and EQ controls to the desired settings.
6.) When you are finished listening press the STANDBY/ON button to return the system to
the Standby (Off) mode.
The display lighting goes off and the display changes from radio frequency to correct time.

RADIO OPERATION

or
or
GB 14
buttons until the display shows the exact
buttons the display begins to move, then