Connecting The Speakers - Onkyo HTP-L50 Instruction Manual

Connecting the speakers

For safety reasons, do not turn on any devices or components
until you have completed all wiring procedures.
Connecting the satellite speakers
Note:
The nominal impedance of this speaker system is 6 . Use
only amplifiers capable of handling this impedance.
Front right
speaker
(RED)
MODEL D-L1
Red
Surround right
speaker
(GRY)
D-L1
MODEL
Gray
L
PREOUT
AUDIO
REMOTE
CONTROL
R
SUB IN OUT IN
WOOFER TV/LINE MD/CDR/TAPE
DIGITAL VIDEO OUTPUT
OPTICAL
OUT IN S VIDEO VIDEO
Before connecting
Prepare the supplied speaker cables as shown below.
Strip off the end of the
speaker cable insulation.
Connecting to the speaker terminals
Push down the lever.
6
Center
speaker
(GRN)
MODEL D-L1
Green
SURROUND
FRONT SPEAKERS
SPEAKERS
R L R CENTER L
SURROUND
ANTENNA FRONT SPEAKERS
SPEAKERS
R L R L AC INLET
CENTER
ANTENNA
AM FM 75
Y P P
B R
COMPONENT
Twist together the exposed
wires strands.
Insert the Release the lever.
exposed wires
into the hole.
• Connect the input terminals on the rear of the satellite
speakers to the speaker output terminals on the AV
amplifier or receiver using the supplied speaker cables as
shown in the diagram to the left.
• Each speaker cable should be connected to the speaker
terminal of the same color.
The speaker's terminals are colored as follows.
Front left speaker (+)
Front right speaker (+)
Center speaker (+)
Front left
speaker
Surround left speaker (+) : blue
Surround right speaker (+): gray
(WHT)
MODEL D-L1
Notes:
• Make sure that the positive (+)
and negative (–) speaker cables
do not contact each other. If they
do, a short-circuit may occur,
causing damage to the amplifier.
White
• Be sure to connect the speaker cables with the correct
polarity (+ and –) and with the proper left-right speaker
orientation. If connected incorrectly, the resulting sound
space with sound unnatural.
Surround left
• Pull the speaker cable lightly to ensure that it is connected
speaker
firmly.
(BLU)
D-L1
MODEL
Connecting the subwoofer
When used together with an AV amplifier or receiver with
surround playback capabilities, be sure to connect its SUB
WOOFER PREOUT terminal to the subwoofer SL-105 using
Blue
the supplied pin-cord.
If you connect the subwoofer SL-105 using speaker cables,
depending on the settings at the AV amplifier or receiver, bass
signals may be cut for an unsatisfactory bass output. For more
details regarding connection procedures, refer to the manuals
that came with your AV amplifier or receiver.
Connect the SUB WOOFER PREOUT terminal on your AV
amplifier or receiver to the subwoofer rear panel using the
supplied pin-cord as shown in the diagram above.
Note:
If the amplifier has a subwoofer terminal, since its output is
monaural, connect it to the low level LINE INPUT L(MONO)
terminal on the subwoofer SL-105.
: white
: red
: green
L
ANTENNA SURROUND
SPEAKERS
PREOUT
R L
AUDIO
REMOTE
ANTENNA
CONTROL
R
AM FM 75
SUB IN OUT IN
WOOFER TV/LINE MD/CDR/TAPE
DIGITAL VIDEO OUTPUT
Y P B P R
OPTICAL
OUT IN S VIDEO VIDEO COMPONENT
(Supplied pin-cord)
PREOUT
AUDIO
SUB
WOOFER
LINE
SPEAKER LEVEL
INPUT
_ _
+ +
R L
INPUT
FROM
AMP/RECEIVER
L
(MONO)
OUTPUT
R
TO SPEAKERS
_ _
+ +
R L
FRONT SPEAKERS
R CENTER L AC INLET
AUTO STANDBY
OFF ON