Getting To Know Your Speaker Package - Onkyo HTP-750 Instruction Manual

Getting to know Your Speaker Package

Front, Center, Surround, and
Surround back speakers (SKF-750XF,
SKC-750XC, SKM-750XS, SKB-750X)
Rear
1
A
Keyhole slots
These keyhole slots can be used to wall-mount the
speaker.
They can also be used to install the speaker on the
stand.
B
Speaker terminals
These push terminals are for connecting the speaker
to your AV Receiver with the supplied speaker
cables. The supplied speaker cables are color-coded
for easy identification. Simply connect each cable to
the same-colored positive speaker terminal.
C
Speaker mount/bracket inserts
These threaded inserts can be used to attach the
speaker either horizontally or vertically to a speaker
mount or bracket.
Note:
Use commercially available 1/4" screws to attach
the speaker to a speaker mount or bracket.
6
Speaker Stand
Follow the steps below to install each front speaker onto
a speaker stand.
1
3
2
2
3
Loosen the bundled speaker cable, insert
the cable into the hole of the base panel
from the top, then pull the cable out and
downward.
Pipe stand
Speaker cable
Do not pull the speaker cable too hard, as it may
break.
Attach the pipe stand to the base panel in
the correct orientation so that the screw
holes on the pipe stand and the holes in
the base panel will align. Tighten the
screws firmly.
×
Screws (small, 2)
Guide the speaker cable along the arrow
on the base panel bottom, and snap the
cable into the notch on the perimeter of
the base panel bottom.
Notch
Base panel surface
Pipe stand
Align.