Onkyo HTP-750 Instruction Manual page 9

Getting to know Your Speaker Package —Continued
Subwoofer (SKW-750X)
■ Front
■ Rear
2
To AC outlet
A
STANDBY/ON indicator
Red: Subwoofer in standby mode
Blue: Subwoofer on
With the Auto Standby function, the SKW-750X
automatically turns on when an input signal is
detected in Standby mode. When there's no input
signal for a while, the SKW-750X automatically
enters Standby mode.
B
OUTPUT LEVEL control
This control is used to adjust the volume of the sub-
woofer.
C
LINE INPUT
This RCA input should be connected to the sub-
woofer pre out on your AV receiver with supplied
RCA cable.
Note:
The Auto Standby function turns the subwoofer on when
the input signal exceeds a certain level. If the Auto
Standby function does not work reliably, try slightly
increasing or decreasing the subwoofer output level on
the AV receiver.
1
SKW-750X
3
If the subwoofer is placed on a hard floor (wood,
vinyl, tile, etc.) and playback is very loud, the sub-
woofer's feet may damage the flooring. To prevent
this, place the supplied pads
underneath the subwoofer's feet.
The pads also provide a stable
base for the subwoofer.
Setting the Subwoofer Level
To set the level of the subwoofer, use the OUTPUT
LEVEL control. Set it so that bass sounds are evenly bal-
anced with the treble sounds from the other speakers.
Because our ears are less sensitive to very low bass
sounds, there's a temptation to set the level of the sub-
woofer too high. As a rule of thumb, set the subwoofer
level to what you think is the optimal level, and then back
it off slightly.
MIN
OUTPUT LEVEL
MAX
9