Installation (Retrofit) - Panasonic FV-05-11VKS1 Installation Insrtuctions

INSTALLATION (NEW CONSTRUCTION) CONTINUED
13. Adjust Pick-A-Flow switch; if used, adjust the
FV-VS15VK1 Multi-Speed module. (Fig.10)
Refer to indication on page 6.
14. Insert the other mounting spring into the slot as
shown and mount grille to fan body. (Fig.11)
CAUTION
Mount grille carefully so that lead wire is
not pinched.

INSTALLATION (RETROFIT)

WARNING
Disconnect power source before working
on unit.
1. Remove the existing fan and cut ceiling openning.
Secure the Flex-Z Fast
tapping screws (ST4.2x20)
screws and put on Flex-Z Fast
Flex-Z Fast TM bracket is installed on joist)
Existing ductwork and wiring left in place. (Fig.12)
2. Follow the step 1, 4, 5 on page 8 and step 7 on
page 9. (Before connect the circular duct to the
adaptor, should pull down the circular duct from
the ceiling)
3. Install the adaptor to Flex-Z Fast
using 2 self-drilling screws. (Fig.13)
4. Secure the fan body to Flex-Z Fast
using 2 self-drilling screws, plug connector to
receptacle and secure the fan body to adaptor
by using machine screw (M4X6). (Fig.14)
CAUTION
Secure machine screw (M4X6) to
hole and not touch the Flex-Z Fast
Please fix the screw carefully to avoid screw
slip teeth.
5. Follow the step 10 to 14 on page 9 to 10.
10
TM bracket to joists by using 4
(Please prepare the
TM bracket before
.
TM bracket by
TM bracket by
the suitable
TM bracket.
Ceiling
Gloves
Grille
Conduit Circular duct
4 Tapping
screws (ST4.2x20)
Ceiling (already existed)
Circular duct
Conduit
Knock-out
hole
Junction box
cover
2 Self-drilling screws
Ceiling
Joist
Ceiling
Machine screw (M4X6)
2 Self-drilling screws (Fix the
flange and Flex-Z Fast bracket through the ceiling)
TM
Ceiling
Grille
Fig.10
Mounting
spring
Fig.11
Unit: inches (mm)
Joist
Fig.12
Mastic or
approved
foil tape
Joist
Fig.13
Flange
Fig.14