Philips SC2009 User Manual page 12

Skin test
Using your Philips Lumea
Attachments
When you use Lumea for the first time or after recent tanning, perform a skin
test on each area to be treated. The skin test is necessary to check your
skin's reaction to the treatment and to determine the correct light intensity
setting for each body area.
1 Choose an area close to the area you intend to treat.
2 Turn on the device. Make sure you select setting 1.
3 Put the device against your skin and press the flash button to release a
flash.
4 Slide the device over the skin to the next area to be treated.
5 Increase the setting by one level, apply a flash and slide the device to the
next area. Repeat this for all levels within the recommended range for
your skin type.
6 After the skin test, wait 24 hours and check your skin for any reaction. If
your skin shows reactions, choose the highest setting that did not result
in any skin reaction for subsequent use.
Placing and removing
To place the attachment, simply snap it onto the light exit window.
To remove the attachment, pull it off the light exit window.
Body attachment
You can use the body attachment to treat unwanted hair on several body
areas below the neckline. You can use it for example for fast treatment of
larger areas like legs.
English
11