Ver. 1.2
(5) Remove the Protective Sheet.
(6) Bend the Protective Tab on the Rear Cover
approx. 180° towards the inside of the machine
as illustrated.
(7) Connect the ADF Harness to CN650 on the
SPC PC Board.
(8) Insert the Harness Clamp into a pre-drilled hole
in the frame (from underside).
Note:
Do not cut the Harness Clamp (Tie-Wrap) when
servicing. Push the release clip on the side to
remove it.
(9) Reinstall the Rear Cover.
(10) Secure the Rear Cover with 10 Screws.
Note:
Align the ADF if required by following the steps
below.
(A) Release 4 Screws.
(B) Adjust the right side of the ADF and the ADF
Mounting Bracket as illustrated.
(C) Secure the ADF with 4 Screws.
373
DP-1520P/1820P/1820E
SEP 2004