Table of Contents
Advertisement
Figure 27
1. Rear access panel
2. Fastener
Installing the Engine Hood
1. To install the hood, align the slot in the hood with
the frame and carefully lower it onto the frame
(Figure 28). Make sure the frame seated correctly
in the engine hood groove before forcing the hood
down. Push down gently to seat the retaining pin.
Figure 28
1. Engine hood
2. Frame
2. Install the collection bag; refer to the Operation
section.
3. Frame
3. Frame mating with slot in
the hood.
Lubrication
Greasing the Bearings
Service Interval: Every 25 hours—Grease all
lubrication points.
Grease Type: No. 2 General Purpose Lithium Base
Grease
1. Park the machine on a level surface and disengage
the blade control switch.
2. Move the motion control levers to the brake position,
stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Clean the grease fittings (Figure 29 and Figure 30)
with a rag. Make sure to scrape any paint off of the
front of the fitting(s).
1. Front caster tire
1. Read the instructions
before servicing or
performing maintenance.
2. Check tire pressure every
25 operating hours.
4. Connect a grease gun to each fitting (Figure 29 and
Figure 30). Pump grease into the fittings until grease
begins to ooze out of the bearings.
5. Wipe up any excess grease.
26
Figure 29
Figure 30
3. Grease every 25 operating
hours.
4. Engine
Advertisement
Table of Contents
