Table of Contents
Advertisement
Operation in the Recycler
Mode
Air is required to cut and recut grass clippings in the
mower housing, so do not set the height-of-cut too low
or completely surround the housing by uncut grass.
Always try to have one side of the mower deck free
from uncut grass; allowing air to be drawn into the
mower deck. When making an initial cut through the
center of an uncut area, operate the machine slower and
back up if the mower starts to clog.
To ensure optimum performance, clean the underside
of the mower housing after each use. If residue is
allowed to build up in the mower housing, cutting
performance can decrease.
For the best performance of the Recycler
• Mow regularly.
• Keep air flow high by overlapping cutting paths
• Use an higher height of cut for taller grass.
• Use sharp blades.
• Travel at slower speeds when mowing taller grass.
Positioning the Seat
The seat can move forward and backward. Position the
seat where you have the best control of the machine
and are most comfortable.
1. Raise the seat and loosen the adjustment knobs
enough to move the seat (Figure 20).
Important: Make sure that the spacers stay in
place when loosening the knobs to move the
seat. Loss of the spacers can result in damage
to the seat.
2. Move the seat to the desired position and tighten
the knobs.
®
1. Adjustment knobs
®
mode:
Adjusting the Motion Control
Levers
The motion control levers can be adjusted higher or
lower for maximum operator comfort.
1. Remove the 2 bolts holding the control lever to the
control arm shaft (Figure 21).
2. Move the control lever to the next set of holes.
Secure the lever with the 2 bolts (Figure 21).
1. Control lever
2. Bolt
3. Repeat the adjustment for the opposite control
lever.
Pushing the Machine by Hand
Important: Always push the machine by hand.
Never tow the machine because damage may
occur.
21
Figure 20
Figure 21
3. Control arm shaft
Advertisement
Table of Contents
